3D Printer Press Auto Bed Leveling Sensor For Anet A8 Tevo Reprap Mk8 I3 | Компьютеры и офис

Self-test: push the nail three times to test,power is.Alarm: LED light flashes if a problem is found in a self-test or surgery.The standard deviation of the repeatable 3d-Press is about 0.005mm, which is accurate.If you choose 3d-touch, 3D printers will give you a pleasant experience with first-class masterpieces.
Innovative electromagnetic: super power saving:In the idle state, while the push is pulled or retracted, there is no current flowing through the solenoid valve, and the standby current in the entire device is lower than 15ma average, while in the working state, while the foot is walking, suddenly about 100ms, the device under 300ma flow .
Low power consumption even further reduces Joule heating to prevent thermal problems.Bed width selection:3d-Press does not use any light and is not close to (inductor/capacitance) sensors.
3d-Press provides high precision through Hall effect control. Therefore, the bed material can be freely chosen.Optimized structure: larger volume:3dPress is a technology intensive person. The build size can be set larger than other existing automatic bed level sensors.
3D-Press is a fully automatic universal 3D printer hot bed leveling probe (automatic leveling probe).Its advantages are simplicity, compactness, high precision, good compatibility, and compatibility with all bed materials, such as glass, metal, wood, plastic, acrylic, etc.
3D-Press can be easily applied due to its small size and simple structure. Collecting information and firmware settings will be an easy task as 3dPress works as an automatic bed leveling sensor as usual.
wiring:
3d-Press wiring:
Wiring 3Pin: Black ( - , GND)
Red (+ 5V)
Blue (control signal)
2PIN: Black ( - , GND) Yellow (Zmin)
Precautions:
Some 3D printer motherboards may have an external 5V power supply if there is insufficient 5V power supply. It is difficult to push theprobe, or the logic circuit protects the master restart during operation. If it is generally recommended to use the DC-DC buck module to take power from the main power supply.
1.+5V and GND should not be connected for a long time.
2. Please try to stay away from strong magnets, motors and fans, etc. with magnetic components
3. Accidental impact on the probe aluminum rod may damage or affect the detection accuracy
4. Adjusting or reassembling the set screw of the probe requires threading glue
5. Install the probe to avoid deformation of the casing
6. Pull the aluminum rod hard Will damage or affect the accuracy of detection
colour:Photo Color
Material:Plastic + metal
Package Contents:
1 * 3D-Press probe white
2 * M2.5 screw
2 * M2.5 nut
1 * DuPont line 2pin mother to mother 1m
1 * DuPont line 3pin mother to mother 1m
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.

<