CJMCU-3DOF inertial measurement combination development board 3 degrees of freedom ADXL203 + ADXRS614 attitude module winder | Электроника

CJMCU-3DOF inertial measurement combination development board 3 degrees of freedom ADXL203 + ADXRS614 attitude module winder | Электроника

CJMCU-3DOF inertial measurement combination development board 3 degrees of freedom ADXL203 + ADXRS614 attitude

None. There is no direct replacement for this part, but we have plenty of alternatives in ourIMU category. This page is for reference only.

The Inertia Measurement Unit Combo Board with the high-precision ADXL203. The ADXL203 sensor is a much higher precision sensor with a range of +/- 1.5g. This small PCB board incorporates the Analog MEMs gyroscope and accelerometer in a tight footprint. The IMU board uses a standard .1 "header and includes all from from both the ADXRS Gyro and ADXL Accelerometer ICs.

We created this board because of the retirement of the Tokin CG-16D piezoelectric sensors. These appliances are now becoming obsolete and difficult to find. The ADXRS sensors from Analog are a great substitute but hobbyists were hindered by the BGA package. ADXRS with the ADXL sensors, the IMU board enables people and hobbyists to easily incorporated yaw and tilt measurements into their projects or robots.

Board comes fully assembled and tested with ADXL203 and ADXRS614. Units come as shown without headers installed. We recommend right-angle break away headers, straight pin headers, or wire up your own cable!